Formed Stainless Steel Grid - Exporter, Manufacturer & Supplier, Pune, India

To inquire, Select Product/s & Click on

Product Code : 11

[Select]

Product Specification

Wire-Resistance & Heating
STARTING / SPEED CONTROL / BUFFER RESISTOR FOR MOTORS:

For starting / Speed Control of A.C or D.C. Motors, resistors are manufactured as per customer's requirement at specified starting torque or for limiting initial inrush current to an acceptable value. Mainly these are used for cranes. Rating can be 2 minute, 5 minute, 10 minute, continuous or intermittent. Material of resistor is normally Stainless steel AISI-304, AISI -410 or AISI 430 or FeCrAl-AISI-406.

QUALITY
Standards Followed

IPSS-1-10-002-82 with amendment no.1 and BS 587 for starting / speed control resistor.
IS 2147 & IS 12063 of 1987 for degree of protection for enclosure.
IS 5 for paint shade.
Any other standard as required can also be followed.

TESTS
(A). ROUTINE TESTS: - FOLLOWING TESTS WILL BE CONDUCTED.

Visual and Dimensional
Insulation resistance value measurement by using 500V megger before and after dielectric test.
Resistance value measurement with Â± 10 % tolerance.
H.V. Test of twice the rated voltage +1000 volts for voltage class below 660 volts.

TYPE TESTS
Temperature rise test i.e., Heat run test if required will be conducted by passing equivalent / rated current for rated / equivalent time keeping IÂ²T Constant through a part of Resistor.

INFORMATION TO BE FURNISHED TO US:
For Starting / Speed Control resistor:

Rotor volts at standstill.
Rotor Current at full load.
Duty rating (Time on / off No. of Cycles).
Starting Torque in percentage of full load Torque.
Material of Resistor.
No. of steps / sections and its resistance values per phase.
Type of enclosure (Protection Class as per IS-12063).
Temperature rise allowed.
Whether terminals should be brought down at one place.
Details of atmospheric conditions at site.

For Buffer resistors

Rotor volts at standstill.
Rotor Current at full load.
Percentage (%) of slip required.

<< Back